Samsung RS257BAWW, Руководство пользователя и инструкция по установке

Страница: 28 / 32

WATER
ICE
28
2) When you press the test button, the ice cube container is
filled with water from the water supply tap.
Check the amount of water (see the illustration below).
If the water level is too low,
the ice cubes will be small.
This is not a problem with the ice maker
but of the water pressure in the pipe.
When this problem occurs, contact
the dealer service center to check the
amount of water supplied.
INSTALLATION OF THE WATER DISPENSER LINE
Remove any residual matter inside the water supply line after installing filter.
Check the amount of water supplied to the ice tray.
CHECK THE WATER LEVEL
Feeler Arm
TEST BUTTON
TOO HIGH
OPTIMUM
LEVEL
1) Lift up (
①
) and pull out (
➁
) the ice maker bucket in the freezer.
ICE MAKER
TOO LOW
1) Turn on the main water supply & shut-off the valve of the
water supply line.
2) Run water through the dispenser until the water runs clear
(6~7 minutes). This will clean the water supply system and
clear air from the lines.
3) Additional flushing may be required in some households.
4) Open the refrigerator door and check if water leaks around
the water filter.
• A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser.
• Before reinstalling the water filter, remove the wine shelf (RS257BA).
NOTE
DA68-01468B(EN) 2006.5.8 10:35AM 페이지28