Chapter 1 Before Installation
RFD01F Series Installation Manual v1.0
4
© Samsung Proprietary and Confidential
Before Installing
Post warning signs in areas where high-voltage cables are installed.
Post ‘off limit’ signs in areas where accidents are most expected.
With guardrails or fences, block open areas such as connecting parts, roof, and
scaffold.
While Installing
The system power must be cut off before installing.
Be careful not to damage or scratch the boards mounted on the system and the
cables among the boards when the system is transported or installed.
Make sure the power switch of power supply is off when installing the system.
Installing the system with power switch on may cause system damage or fatal
human injury when cables are not correctly connected.
Make sure that worker wears protection gloves and goggles to prevent damage
from debris while drilling holes in a wall or ceiling.
Do not wear accessories such as watches and rings in order to prevent electrical
shock.
Never allow foreign substances to be inserted into unused ports by covering them
with a waterproof cap.
To prevent foreign substances, outdoor air and moisture from entering the cable inlet
(including cable gland and conduit), finish it as follows:
- Unused inlet
Use the hole finishing materials including dust cap and rubber packing.
- Cable-installed inlet
After cable installation, block any space in the inlet with tape, compressed
sponge, rubber packing, and silicon.
