Samsung RC***MHXGA, Руководство по установке

Страница: 15 / 44

ENGLISH
15
Installing the Unit
Moving the outdoor unit with a fork lift
Moving the Outdoor Unit
Fasten the outdoor unit by two 8m or longer wire ropes as shown at the figure. To
prevent from damage or scratches, insert a piece of cloth between the outdoor
unit and rope, then move the unit.
Insert the fork into the wooden pallet at the bottom of the outdoor unit carefrully.
Be careful that the fork does not damage the outdoor unit.
• Select the moving route in advance.
• Be sure that moving route is safe from weight of the outdoor unit.
• Do not slant the product more than 30
˚
when carrying it. (do not lay the product down sideways)
• The surface of the heat exchanger is sharp. Be carefule not to be injured while moving and installing.
Plate protection
cloth
Wire rope

The appearance of the unit may be differ
ent from the picture depending on
the model.
Moving the Outdoor Unit by Wire Rope
Deciding on Where to Install the Outdoor Unit
Decide the installation location regarding the following condition and obtain the user’s approval.

The outdoor unit must not be placed on its side or upside down, as the compressor lubrication oil will run into the cooling
circuit and seriously damage the unit.

Choose a location that is dry and sunny, but not exposed to direct sunlight or strong winds.

Do not block any passageways or thoroughfares.

Choose a location where the noise of the Air to Water Heat Pump when running and the discharged air do not disturb any
neighbours.

Choose a position that enables the pipes and cables to be easily connected to the other hydrauric system.

Install the outdoor unit on a flat, stable surface that can support its weight and does not generate any unnecessary noise
and vibration.

Position the outdoor unit so that the air flow directly stream towards the open area.

Place the outdoor unit where there are no plants and animals because they may cause malfunction of outdoor unit.

Maintain sufficient clearance around the outdoor unit, especially from a radio, computer, stereo system, etc.

When installing the outdoor unit near seashore, make sure it is not directly exposed to sea breeze.
If you can not find an adequate place without direct sea breeze, make sure to apply anti-corrosion coating on the heat
exchanger.
Wooden pellet
Fork lift