30 English
Installation instructions
Installation instructions
To adjust flame low setting
Identify which burner is exhibiting too high or too low of simmer rate via
manifold panel graphics.
Simmer Set
Screw
1.
Rotate a knob to “LO” position and
remove the knob from the valve shaft
while the flame is lit.
2.
Carefully push the screw driver into
the C chanel of the valve, until it his
the simmer set screw. Make sure the
screwdriver flathead is seated into the
set screw groove.
3.
Rotate valve set screw clockwise to
decrease “LO” setting flame output, or
rotate set screw counter clockwise to
increase “LO” setting flame output.
WARNING
1.
Do not completely remove the valve set screw from the valve stem. The valve
set screw is an integral part of the gas valve assembly. Removing the valve set
screw will cause gas to leak.
2.
After adjusting the valve set screw, inspect the assembly for gas leaks.
Memo
Install_NX58H56_DG68-00524A-13_EN+MES+CFR.indb 30
Install_NX58H56_DG68-00524A-13_EN+MES+CFR.indb 30
2020-10-13 11:50:35
2020-10-13 11:50:35
