Samsung MWR-WE13, Руководство по установке

Страница: 6 / 24

6
Wired Remote Controller Installation
English 6
Installation
3
Using more than two screws, firmly affix the rear cover of the remote controller to the wall, and then connect
the power(V1, V2) and communication cables(F3, F4), making sure these cables have reasonable length,
to the terminal at the back of the cover.
10 mm (0.4 inch)
or more
10 mm
(0.4 inch)
or more
50 mm(2 inch)
or more
10 mm(0.4 inch)
or more
Screw
hole
Rear cover
Front cover
PCB terminal
Wire (not supplied)
࢘9ʪ˙ͱθʪ˙̈ӱ͝˝ϩ˵ʪθʪɇθʀͱЭʪθࡡ
secure at least 10 mm(0.4 inch)
space of upper side, left side,
right side, and 50 mm(2 inch)
space of bottom side.
࢘ǽͱЇ͔Їϑϩ˙̈ϩϩ˵ʪϑʀθʪиϑ
into the screw holes.
࢘Uͱ͝ͱϩϩ̈˝˵ϩʪ͝ϩ˵ʪϑʀθʪиϑͱ͝ϩ˵ʪ
PCB terminal with excessive force.
Indoor unit
Wired
Remote
Controller
4
Reassemble your Wired Remote Controller.
NOTE
• Align the controller with the upper groove first, and insert it by turning it
downward as shown in the figure.
After assembly, check and confirm that no wires are stuck in the gap
between the rear and front cover.
CAUTION
• When installing a Wired Remote Controller by using a cable longer than 10 m(32.80 ft), you must install the
communication cable and the power cable separately. (Electrical interference can cause your Wired Remote Controller
to malfunction.)
• When installing your Wired Remote Controller on the wall, consider the size of the wire hole, and select a wire with a
proper thickness.
• Wire that is connectable to Wired Remote Controller PCB.
– If you install the Wired Remote Controller by reclaiming, install it according to U-terminal cable specification.
– If you install the Wired Remote Controller by using four pieces of PVC wire, remove the 30 cm(12 inch) of the sheath
of the cable and install it only with the four pieces of wires. (Recommended specification: AWG20)