Your system is equipped with a clock which allows you to
turn your system on and off automatically.
You should set the clock:
When you first purchase the micro component system
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
Switch the system on by pressing
( )
.
Press the
TIMER/CLOCK
button twice.
Result:
CLOCK
is displayed.
Press the
PROGRAM/SET
button.
Result: The hour flashes.
To...
Press...
Increase the hours
Decrease the hours
When the correct hour is displayed, press the
PROGRAM/SET
button.
Result: The minutes flash.
To...
Press...
Increase the minutes
Decrease the minutes
When the correct time is displayed, press the
PROGRAM/SET
button.
Result: "
TIMER SET
" appears in the display.
The current time is now set.
You can display the time, even when you are using another
function, by pressing this
TIMER/CLOCK
button once.
You can use
/
buttons on the front panel to instead of
/
buttons on the remote control.
1
2
3
4
5
6
7
You can view the various functions available on your system.
Press the
DEMO/DIMMER
button.
Result: The various functions available are listed in turn on the
display.
All these functions are described in detail in this booklet.
For instructions on how to use them, refer to the appropriate
sections.
To cancel this function, press the
DEMO/DIMMER
button again.
2
1
You can adjust the brightness of the VFD display depending
on the surrounding lighting conditions.
Press the
DEMO/DIMMER
button.
Your selection switches each time the button is pressed:
DIMMER ON(Dim)
➞
DIMMER OFF(Bright)
.
1
DIMMER Function
10
GB
DEMO Function
Setting the Clock
4,6
1
2
3,5,7
4,6
MM-ZJ9-GB(DAB)-RDS 11/12/04 8:33 Page 10
