28
ENGLISH
INSTALLATION & WIRING INSTRUCTIONS
IMPORTANT NOTE :
The mains lead on this equipment is supplied with a moulded plug
incorporating a fuse.
The value of the fuse is indicated on the pin face of the plug and, if it
requires replacing, a fuse approved to BS1363 of the same rating must be
used.
Never use the plug with the fuse cover omitted if the cover is detachable. If
a replacement fuse cover is required, it must be of the same colour as the
pin face of the plug.
Replacement covers are available from your Dealer. If the fitted plug is not
suitable for the power points in your house or the cable is not long enough
to reach a power point, you should obtain a suitable safety approved
extension lead or consult your Dealer for assistance. However, if there is no
alternative to cutting off the plug, remove the fuse and then safely dispose
of the plug. Do not connect the plug to a mains socket, as there is a risk of
shock hazard from the bared flexible cord.
WHAT TO DO IF YOU ARE IN DOUBT OR
HAVE A PROBLEM
Becoming familiar with a new appliance always takes a little time. If you
have any of the problems listed below, try the solutions given. They may
save you the time and inconvenience of an unnecessary service call.
The following are normal occurrences.
•
Condensation inside the oven
• Air flow around the door and outer casing
• Light reflection around the door and outer casing
• Steam escaping from around the door or vents
The food is not cooked at all
•
Have you set the timer correctly and pressed the
Start/+20s
(
)
button?
• Is the door closed?
• Have you overloaded the electric circuit and caused a fuse to blow or a
breaker to be triggered.
The food is either overcooked or undercooked
•
Was the appropriate cooking length set for the type of food?
• Was an appropriate power level chosen?
Sparking and cracking occur inside the oven (arcing)
•
Have you used a dish with metal trimmings?
• Have you left a fork or other metal utensil inside the oven?
• Is aluminum foil too close to the inside walls?
The light bulb is not working.
• The Light bulb should not be replaced in person for safety reasons.
Please contact nearest authorised Samsung customer care, to arrange
for a qualified engineer to replace the bulb.
The oven causes interference with radios or televisions.
•
Slight interference may be observed on televisions or radios when the
oven is operating. This is normal. To solve this problem, install the oven
away from televisions, radios and aerials.
•
If interference is detected by the oven’s microprocessor, the display
may be reset. To solve this problem, disconnect the power plug and
reconnect it. Reset the time.
MJ26A6013AT_EU_DE68-02570D-00_EN.indd 28
MJ26A6013AT_EU_DE68-02570D-00_EN.indd 28
24/3/2021 3:10:14 PM
24/3/2021 3:10:14 PM
