Samsung ME21K6000A, Руководство по установке

Страница: 17 / 40

17
Step-by-step installation guide
pinch the cord or lift the oven by pulling cord.
1 . Lift the microwave, tilt
it forward, and hook
the slots at the back
bottom edge onto the
four lower tabs of the
mounting plate.
2 . Rotate the front of
the oven up against
the cabinet bottom.
3 . Insert a self-aligning screw through the top
center cabinet hole. Temporarily secure the oven
by turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.) Be sure to keep the power
cord tight. Be careful not to pinch the cord,
especially when mounting flush to the
bottom of the cabinet.
Cabinet Front
Filler Block
Microwave Oven Top
Self-Aligning Screw
Equivalent to
Depth of
Cabinet Recess
Cabinet Bottom Shelf
Equivalent
to Depth of
Cabinet Recess
Cabinet Bottom Shelf
Microwave Oven Top
Cabinet Front
Filler Block
Self-Aligning Screw
4 . Attach the microwave oven to the top cabinet.
5 . Insert the 2 self-aligning screws through the
cabinet bottom and, if used, through the filler
blocks into the outer top of the unit. (See the
illustration above). Continue to support the unit
until both screws are inserted and engaged at
least two full turns, then fully tighten both screws
until the unit is secure.
6 . Install the grease filters. See the Owner’s Manual
packed with the microwave for instructions.
NOTE : For models with installed grease filters, you
do not need to install a filter
E. CONNECT THE DUCTWORK
FOR OUTSIDE TOP
EXHAUST
House Duct
House Duct
1 . Extend the house duct down to connect to the
exhaust adaptor.
2 . Seal the exhaust duct joints using duct tape.
ME21K6000AS_AA_DE68-04108C-00_EN.indd 17 5/20/2016 5:06:34 PM