13
Step-by-step installation guide
B1. ADAPTING MICROWAVE BLOWER
FOR RECIRCULATION
2
. Lift up the
blower plate.
1
. Remove and save screw
that holds blower plate to
microwave.
Back of
Microwave
NOTE
: The exhaust adaptor with damper is not
needed for recirculating models. You may want to
save them for possible future use.
3
. Remove screw holds blower mortor and
carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
blower mortor screw
CAUTION
: Do not touch blade of blower for
preventing crack and break. Hold outer case when
the blower pull out or back into.
4
. Roll the blower unit 90 ° so that fan blade
openings are facing toward the front of the
microwave.
Back of
Microwave
Back of
Microwave
Before Roll
After Roll
5
. Place the blower unit back into the opening.
CAUTION
: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
6
. Secure blower unit to microwave with the screw.
B2. INSTALLING THE CHARCOAL
FILTER
1
. Remove screws on top of grille using a #1
Phillips screwdriver.
2
. Open the door.
3
. Remove the grille.
• After push left, Pull the grille straight off.
Charcoal
Filter
4
. Install the charcoal filter. When properly installed,
the wire mesh of the filter should be visible from
the front.
5
. Reinstall the grille and the screws.
6
. Close the door.
Insert mesh-side up
B. RECIRCULATING (NON-VENTED DUCTLESS)
SMH8165_XAA DE68-03587A-07-EN.indd 13
13/01/2015 17:40:31
