English 17
St
ep-b
y
-s
tep ins
tallation g
uide
Equivalent
to Depth
of Cabinet
Recess
Cabinet Bottom Shelf
Microwave Oven Top
Cabinet Front
Filler Block
Self-Aligning
Screw
1.
Lift the microwave, tilt it forward,
and hook the slots at the back
bottom edge onto the four lower
tabs of the mounting plate.
2.
Rotate the front of the oven up
against the cabinet bottom.
3.
Insert a self-aligning screw
through the top center cabinet
hole. Temporarily secure the oven
by turning the screw at least
two
full turns
after the threads have
engaged. (It will be completely
tightened later.) Be sure to keep
the power cord tight.
Be careful not
to pinch the cord, especially when
mounting flush to the bottom of
cabinet.
Thickness of cabinet
1
/
16
~
15
/
16
˝
Supporter
NOTE
If Cabinet Thickness is
Under 1 ˝, Use Supporter.
1~2˝
NOTE
If Cabinet Thickness
is over 1 ˝, Remove
Supporter from the Self-
Aligning Screw.
NOTE
The self-aligning screw can be installed up to 1
15
/
16
˝ (49mm).
D. Mount the microwave oven
FOR EASIER INSTALLATION AND
PERSONAL SAFETY, WE RECOMMEND
THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
IMPORTANT
:
Do not grip or use the
handle during installation.
NOTE
•
If your cabinet is metal, use the
nylon grommet in the power cord
hole to prevent the cord from being
cut.
•
Filler blocks are required when
mounting this unit under any cabinet
with a recessed bottom or front
overhang. (See page
IMPORTANT
:
The case damage that will
occur from over tightening
screws if you do not use
filler blocks is not covered
under warranty.
IMPORTANT
:
Be careful not to damage
the lower Lamp Glass during
handling.
NOTE
When mounting the microwave oven, thread the power cord through hole in the
bottom of the top cabinet. Keep it tight throughout Steps 1–3. Do not pinch the
cord or lift the oven by pulling cord.
Install_ME11A7510DG_AC_DE68-04709B-01_EN+CFR.indb 17
Install_ME11A7510DG_AC_DE68-04709B-01_EN+CFR.indb 17
2022-01-20 오전 10:09:57
2022-01-20 오전 10:09:57
