English-
76
T
R O U B L E S H O O T I N G
Problem
Possible Solution
Make sure that the devices connected support the Anynet.
Remove devices from the new Anynet product groups that
are not supported by the Anynet version currently running on
your TV.
Then go to [Settings] in the Anynet menu and select
[Typical Setup] or [Customized Setup].
Connect the video cable of the device to the TV according to
the connection diagram before use.
Check to see if the video cable is connected to the same place
now as it was at the time you selected the Connection Setting.
To re-connect the video cable to a different location, re-select
the Connection Setting and choose a device to watch.
If the TV is in VCR mode, see if the tape has any noise.
The device may not be able to detect the video signal if the
noise level is high.
Connect the video cables of the VCR properly according to the
connection diagram.
Then go to [Setups] in the Anynet menu and select [Typical
Setup] or [Customized Setup]. (After selecting the connection
settings, make sure that the Anynet device is selected for VCR
viewing in the pop-up window.)
If the cables are connected properly, see if the video cable of
the VCR is damaged.
See if there are Anynet devices connected.
The Anynet System supports only the Anynet devices.
If you have Anynet devices to connect, connect the devices
properly according to the connection diagram.
Then go to [Setups] in the Anynet menu and select
[Typical Setup] or [Customized Setup].
You cannot use the “ Play DVD ” or “Play VCR ” functions
while the device is recording. Stop the recording before you use
the “Play” functions.
653T-01-82 Eng.qxd 11/26/04 10:17 AM Page 76
