English-47
Power Saver
This set has a built-in power management system called PowerSaver. This system saves energy by
switching your set into a low-power mode when it has not been used for a certain period of time.
The available modes are “On”, “Standby”, “Sleep”, and “Deep Sleep”. PowerSaver operates with a VESA
DPMS compliant video card installed in your computer. You use a software utility installed on your
computer to set up this feature.
State
Normal Operation
Power-Saving Function mode
(EPA/NUTEK)
Horizontal Sync
Active
Inactive
Vertical Sync
Active
Inactive
Power Indicator
Off
Red, Blinking (1 sec interval)
Power Consumption
40W
Less than 3W
➣
This set automatically returns to normal operation when horizontal and vertical sync
are restored.
This occurs when you move the computer’s mouse or press any key on the keyboard.
Troubleshooting: Before Contacting Service Personnel
In PC mode, the image is not stable and
may appear to vibrate.
In PC mode, the image is not centred on
the screen.
◆
Check that the display resolution and frequency from your
computer or video board is an available mode for your set.
On your computer check: Control Panel, Display, Settings.
◆
If the setting is not correct, use your computer utility programme to
change the display settings.
◆
Adjust the horizontal and vertical position.
Your set supports multiscan display functions within the
following frequency domain:
Horizontal frequency(kHz)
Vertical frequency(Hz)
Maximum refresh rate
(at 75Hz)
30~69
50~75
1024
X
768
04-BN68-00438S-01Eng.qxd 6/15/04 8:43 AM Page 47
