English-59
Installing the Wall Mount Kit (LA46M51B)
Insert the screw
into the plastic
hanger. (See the figure below)
Mount the product on the wall
bracket and make sure it is
properly fixed to the left and right
plastic hangers.
Be careful when installing the
product on the bracket as fingers
can be caught in the holes.
Make sure the wall bracket is
securely fixed to the wall, or the
product may not stay in place after
installation.
2
Remove the 4 screws on the back of the
product.
3
Fix the product to the wall bracket.
Hold the product at the top in the center and
pull it forward (direction of the arrow) to
adjust the angle. (See the figure to the right)
You can adjust the bracket angle between
-2° and 15°.
How to assemble the Wall Mount Bracket
Wall Bracket Angle Adjustment
The shape of the product may vary depending on the model.
(The assemblies of the plastic hanger and the screw are the same)
Adjust the bracket angle to -2° before installing it on the wall.
Remove safety pin (
) and insert the 4
product holders into the corresponding
bracket holes (
). Then place the
product (
) so that it is firmly fixed to
the bracket. Make sure to reinsert and
tighten the safety pin (
) to securely
hold the product to the bracket.
Tighten the 4 screws in step 2 (plastic
screw
) to the rear holes of
the product.
PDP
Make sure to use the top center, and not
the left or the right side of the product to
adjust the angle.
Wall Bracket
Wall
BN68-00926M-01Eng.qxd 11/1/05 4:24 AM Page 59
