Command Line Interface
4-240
4
Related Commands
spanning-tree portfast (4-240)
spanning-tree portfast
This command sets an interface to fast forwarding. Use the
no
form to disable fast
forwarding.
Syntax
[
no
]
spanning-tree
portfast
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This command is used to enable/disable the fast spanning-tree mode for the
selected port. In this mode, ports skip the Discarding and Learning states, and
proceed straight to Forwarding.
• Since end-nodes cannot cause forwarding loops, they can be passed through
the spanning tree state changes more quickly than allowed by standard
convergence time. Fast forwarding can achieve quicker convergence for
end-node workstations and servers, and also overcome other STA related
timeout problems. (Remember that fast forwarding should only be enabled for
ports connected to a LAN segment that is at the end of a bridged LAN or for
an end-node device.)
• This command is the same as
spanning-tree edge-port
, and is only included
for backward compatibility with earlier products. Note that this command may
be removed for future software versions.
Example
Related Commands
spanning-tree edge-port (4-239)
spanning-tree port-bpdu-flooding
This command floods BPDUs to other ports when spanning tree is disabled globally
or disabled on a specific port. Use the
no
form to restore the default setting.
Syntax
[
no
]
spanning-tree
port-bpdu-flooding
Default Setting
Enabled
Console(config)#interface ethernet 1/5
Console(config-if)#bridge-group 1 portfast
Console(config-if)#
Содержание iES4028F
