GB
GB
FM antenna connection
1. Connect the FM antenna supplied to the FM 75
Ω
COAXIAL terminal.
2. Slowly move the antenna wire around until you
find a location where reception is good, then
fasten it to a wall or other rigid surface.
• If reception is poor, connect an outdoor antenna.
Before attaching a 75
Ω
coaxial cable (with a standard
type connector), disconnect the supplied FM antenna.
AM
(MW/LW)
antenna connection
1. Connect the AM loop antenna supplied
to the AM and terminals.
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna
connected).
12
Connecting the FM and AM
(MW/LW)
Antennas
11
A cooling fan is mounted on the rear panel of the center unit to
prevent abnormal temperature inside the center unit, thus assuring
normal operation. The cooling fan automatically starts rotating to
supply external cool air to the inside of the center unit when the
internal temperature exceeds the specified limit.
For safety, observe the following carefully.
• Make sure there is good ventilation around the center unit. Poor
ventilation could overheat and damage the canter unit.
• DO NOT block the cooling fan and the ventilation openings or
holes. (If they are blocked by a newspaper or cloth, etc., the heat
may not be able to escape.)
(About the cooling fan)
AUX Connections
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.
AUX IN
VIDEO
VIDEO OUT
ANTENNA
S-VIDEO
SPEAKERS
SPEAKERS
AV OUT
L
R
AUX IN
VIDEO
Y/C
COMP.
VIDEO OUT
ANTENNA
S-VIDEO
AM
R-FRONT-L
R-REAR-L
WOOFER
CENTER
6
6
6
3
1
2
3
ANTENNA
If FM reception is poor,
connect outdoor FM antenna
(not supplied).
FM Antenna (supplied)
AM Loop Antenna
(supplied)
If AM reception is
poor, connect an
outdoor AM
antenna(not
supplied).
AUX IN
VIDEO
VIDEO OUT
ANTENN
A
S-VIDEO
SPEAKERS
SPEAKERS
AV OUT
L
R
AUX IN
VIDEO
Y/C
COMP.
VIDEO OUT
ANTENNA
S-VIDEO
AM
R-FRONT-L
R-REAR-L
WOOFER
CENTER
6
6
6
3
L
R
VIDEO IN
TV
External Analog
Components
Audio Cable (Red/White)
To view pictures from
the external input (AUX),
first connect the VIDEO
IN jack (VIDEO) and
then connect the VIDEO
OUT jack.
Connect to external equipment with
analog outputs.
Example: Video, TV, etc.
•
Always connect the video and
audio connection cables to the
equivalent colored jack.
Press the AUX button and select AUX IN.
Making Analog Input Selection
Press the Function button and select AUX IN.
Remote Control
Main Unit
If the external analog
component has only one
output jack, you may connect
either L or R.
Cooling fan (See “About Cooling Fan” below.)
