English
19
02
Connections
Installing the Speakers on the Tallboy Stand
Turn the Stand Base upside-down and
connect it to the Stand.
Insert small screws (4x20, For connecting
Stand & Stand Base) clockwise into the four
holes marked using a screwdriver as shown
in the illustration.
CAUTION
When you use a torque screwdriver, be
careful not to put excessive force.
Otherwise, it runs idle or can be damaged.
(torque screwdriver- below 15 kg.f.cm)
Connect the upper Speaker to the
assembled Stand.
Insert another large screw (5x15, For
connecting Speaker & Stand) clockwise into
the hole on the rear of the speaker using a
screwdriver.
This is the appearance after the speaker is
installed. Follow this steps to install other
speaker.
1.
2.
!
3.
4.
5.
4
2
Stand
Stand
Base
1
3
Stand
Speaker
5
or
Connecting The Speakers
Press down the terminal tab on the back of the speaker.
Insert the black wire into the black terminal (–) and the red wire into the
red (+) terminal, and then release the tab.
Connect the connecting plugs to the back of the product by matching
the colors of the speaker plugs to the speaker jacks.
With the product turned off, insert the TX card into the TX Card
Connection (WIRELESS) on the back of the product.
Hold the TX card so that the label "WIRELESS" faces
upward and insert the card into the port.
The TX card enables communication between the product
and the wireless receiver module.
Connect the left and right surround speakers to the wireless
receiver module.
Plug the power cord of the wireless receiver module into the
wall outlet.
Turn on the product. The product and wireless receiver
module will now communicate with each other and you will
hear sound from the Surround speakers.
1.
2.
3.
4.
•
•
5.
6.
7.
Black
Red
FM ANT
WIRELESS
VIDE
AUX IN
COMPONENT OUT
FM ANT
VIDE
AUX IN
COMPONENT OUT
TX card
HT-D5550W_XY_0221.indd 19
HT-D5550W_XY_0221.indd 19
2011-03-18 9:23:07
2011-03-18 9:23:07
