20
English
Connections
NOTE
Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too
close to the product, some sound interruption may be heard due to interference.
If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device
that uses the same frequency (2.4/5.8GHz) near the product, some sound interruption may be heard due to
interference.
The transmission distance from the product to the wireless receiver module is about 33 feet (10m), but may
vary depending on your operating environment. If a steel-concrete wall or metallic wall is between the product
and the wireless receiver module, the system may not operate at all, because the radio wave cannot
penetrate metal.
If the product doesn't make wireless connection, the product needs ID Setting between the product and
wireless receiver module. Insert the TX card in the rear of the product before entering Standby mode.
Press "0"
"1"
"3"
"5", and "5" using the numeric buttons on the remote control. You will see a message
of “W INT” on the screen.
With the wireless receiver module turned on, press “ID SET” button on the back of the wireless receiver
module for 5 seconds.
CAUTION
Use the provided TX card only.
If a different TX card is used, the product may be damaged or the card may not be removed easily.
Do not insert the TX card upside down or in the reverse direction.
Insert the TX card when the product is turned off. Inserting the card when it is turned on may cause a
problem.
If the TX Card is inserted and wireless receiver module setting is complete, sound is not output from the
surround Speaker connectors on the product.
The wireless receiver antenna is built into the wireless receiver module. Keep it away from water and moisture.
For optimal listening performance, make sure that the area around the wireless receiver module location is
clear of any obstructions.
If no sound is heard from the wireless receiver module, switch the mode to DVD 5.1 channel or Dolby
ProLogic II .
In 2-CH mode, no sound will be heard from the wireless receiver module.
✎
!
HT-D550-XU-ENG-1228.indd 20
HT-D550-XU-ENG-1228.indd 20
2011-12-29 11:15:27
2011-12-29 11:15:27