26
English
Connections
Wireless Network
You can connect to the network with a Wireless IP sharer.
A wireless AP/IP router is required to make a wireless network connection. Connect the wireless
LAN adapter to the Wireless LAN Adapter on the rear panel of the product.
- This unit is compatible with the supplied Wireless LAN Adapter.
- You can also use the wireless network by connecting the Wireless LAN Adapter Gender to the
Wireless LAN Adapter.
Set the network options. (See page 37)
NOTE
You must use a wireless IP sharer that supports IEEE 802.11 a/b/g/n. (n is recommended for stable operation of the
wireless network.)
Wireless LAN, by its nature, may cause interference, depending on the use condition (AP performance, distance, obstacles,
interference by other radio devices, etc).
Set the wireless IP sharer to Infrastructure mode. Ad-hoc mode is not supported.
When applying the security key for the AP (wireless IP sharer), only the following is supported.
Authentication Mode : WEP, WPAPSK, WPA2PSK
Encryption Type : WEP, AES
For the AllShare function, a PC must be connected in the network as shown in the fi gure.
Connecting the FM Antenna
Connect the FM antenna supplied to the FM
75
Ω
COAXIAL Jack.
Slowly move the antenna wire around until
you fi nd a location where reception is good,
then fasten it to a wall or other rigid surface.
NOTE
This product does not receive AM broadcasts.
1.
2.
✎
1)
2)
1.
2.
✎
WI
iPod
FM ANT.
WI
iPod
FM Antenna (supplied)
HDMI OUT
HDMI OUT
COMPONENT OUT
VIDEO OUT
LAN
AUX IN
WIRELESS LAN
HDMI OUT
COMPONENT OUT
VIDEO OUT
LAN
AUX IN
Wireless IP sharer
Wireless LAN Adapter
Networking with PC for
AllShare function
(See pages 60~61)
PC
Broadband
service
OR
HT-C5500D_ELS_ENG_0322.indd 26
HT-C5500D_ELS_ENG_0322.indd 26
2010-03-22 4:25:33
2010-03-22 4:25:33
