14
English
Connecting the TV to a SBB or STB
ETH MODEM
TV Rear Panel
Data Cable
• Connect the
DATA
jack of the TV to the [ETH MODEM] jack of the STB (SBB) with the Data cable.
✎
Use data communication.
• IR signals sent by the remote control to the TV or SBB / STB must meet the following specification to use IR pass
through function.
IR signal receiver specification
‒ Band pass filter centre frequency: 37.9
㎑
‒ Carrier Frequency, Duty 50%
‒ Minimum Burst Length (tburst): 12 pulses (316 us)
‒ Minimum Gap Time Between the burst (tburst gap): 16 pulses (422 us)
‒ Minimum Gap Time between the data commands (tpause): 25
㎳
¦
List of Vendors and Compatible Data Cables Supplied with the TV
• Confirm that you are using the correct data cable for your vendor. Refer to the code label on the data cables.
CON B
CON A
1
6
6
1
STB SIDE
TV SIDE
CON A
6: NC
5: IR
4: GND
3: Rx
2: Tx
1: Nc
1: NC
2: GND
3: Rx
4: NC
5: Tx
6: IR
CON B
CON A
CON B
6
5
2
4
5
3
3
2
✎
Operation Specification of Data Cable(RJ12) : RS232
