CODE
CAUSE
REASON / SOLUTION
E-27
Oven sensor
opened
(over 2950Ω)
1. Disconnect oven sensor from control, measure the
sensor resistance:1080Ω at room temp, replace oven
sensor if abnormal.
2. If the sensor resistance is normal, check the wire
terminal or the wire on harness.
3. Measure resistance of the oven sensor connector on
main PCB (Normal: 2850Ω)
E-28
Oven sensor
shorted.
(Under 930Ω)
E-08
Oven heating
error
If the oven temperature can not reach 100˚F(38˚C) within 10
minutes while oven is working, “E-08” will be displayed and
buzzer will sound.
E-0A
Oven
overheating
over
If the oven temperature is higher than 650˚F(343˚c) while
oven is working, “E-0A” will be displayed and buzzer will
sound. (Excluding the case of self-cleaning)
E-0E
Door
locking
error
When door lock does not work, after 1 minute elapsed, It
will display “E-0E” and buzzer is beeping also . Press
Cooking Time & Delay Start keys at the same time for 3
seconds to release.
SE/
tE
Shorted
key
If any key is held for over 10 seconds or if there is a short
circuit between main PCB and cable connector or keypad
ribbon, “SE” will be displayed and the buzzer will sound.
E-0C
Partition
switch
error
This error code is for dual oven models only.
Partition plate is not in place.
Partition switch defect. (The resistance of partition switch
should be
1750 ~ 1850Ω).
Partition switch wire harness dropped off.
PCB is defective.
For NE599N1PBSR/AC
E-81
Sub PCB
communica
tion error
1. Check whether connector(CN02) of sub PCB is
connected properly.
2. Check whether connector(CN201) of main PCB is
connected properly.
3. If there is no problem with connection between sub PCB
and main PCB, replace the sub PCB.
E-83
Main PCB
communica
tion error
1. Check whether connector(CN201) of main PCB is
connected properly.
2. Check whether connector(CN02) of Sub PCB is
connected properly.
3. If there is no problem with connection between Sub PCB
and main PCB, replace the main PCB.
Error Code List for Range Ovens
