Installation Instruction
_31
07 INS
T
ALLA
TION INS
TRUC
TION
Installation instruction
WARNING : Electrical Shock Hazard!
Disconnect electrical power before installing dishwasher.
Failure to do so can result in death or electrical shock.
CAUTION:
The installation of the pipes and electrical equipments should be done by professionals.
• Keep this instruction manual in a safe place for future reference. If the appliance is sold, given away
or moved, please ensure the manual is kept with the machine, so that the new owner may benefit
from the advice contained within it.
• Please read this instruction manual carefully: it contains important information regarding the safe
installation, use and maintenance of the appliance.
• If the appliance must be moved at any time, keep it in an upright position; if absolutely necessary, it
may be tilted onto its back.
Positioning and leveling
1.
Remove the appliance from all packaging and check that it has not been damaged during
transportation. If it has been damaged, contact the retailer and do not proceed and further with the
installation process.
2.
Check the dishwasher by placing it so that its sides or back panel are in contact with the adjacent
cabinets or even with the wall. This appliance can also be recessed under a single worktop (see the
Assembly instruction sheet).
3.
Position the dishwasher on a level and sturdy fl oor. If the fl oor is uneven, the front feet of the appliance
may be adjusted until it reaches a horizontal position (the angle of inclination must not exceed 2
degrees). If the appliance is levelled correctly, it will be more stable and much less likely to move or
cause vibrations and noise while it is operation.
Connecting the water and electricity supplies
• Connection to the water and electricity supplies should only be performed by a qualified technician.
• The dishwasher should not stand on top of the water hoses or the electricity supply cable.
• The appliance must be connected to the water supply network using new piping. Do not use old
piping.
Connecting the water inlet hose
Connect the cold water supply hose to a threaded 3/4(inch)
connector and make sure that it is fastened tightly in place. If
the water pipes are new or have not been used for an extended
period of time, let the water run to make sure that the water is
clear and free of impurities. If this precaution is not taken, there
is a risk that the water inlet can get blocked and the appliance
could be damaged.
DW4000KM-00000A-00_EN (Basic)_160323.indd 31
DW4000KM-00000A-00_EN (Basic)_160323.indd 31
2016-03-23 1:14:33
2016-03-23 1:14:33