GB-33
GB
GB-32
D
I
G
I
T
A
L
S
A
T
E
L
L
I
T
E
R
E
C
E
I
V
E
R
4.4 Common Interface (for model DSB-B350T)
This STB has 2 slots of common interface for Viaccess, Conax,
Cryptoworks, Nagravision, Irdeto.
4.5 Reset
4.5.1 Factory Default
This is to restore the factory set values in case the user has
encountered some problems after changing any new values of
channel data and others, which may be in error. Select Factory
Default menu in Reset menu and press
OK
key. If you want to
continue, select confirm using
BLUE(
i
)
key in the warning
window. The receiver will be reset to settings automatically.
Please note that the Factory Default procedure may take a
few seconds.
4.5.2 Delete All channel
In this option, your receiver delete the stored all channel.
Press
OK
key or
key. At the request window, select “Yes” to
delete all channels or select “NO” to exit.
4.6 Change PIN Code
In this option, you need to enter the current PIN code at the
first cursor, and at the second cursor enter the desired
PIN code. To confirm, you need to enter the new PIN
code again.
Please remember the PIN code should be a 4 digit numerical
value.
THE FACTORY PRESET PIN Code : 0000
OPERATING THE RECEIVER
Problem
Possible cause
Solution of the problem
The device, packaging material (e.g. Styrofoam) and the batteries must never be disposed
of with household refuse. Please obtain appropriate information about the regulations in your
community, and dispose of all refuse in accordance with regulations at the separate
locations provided.
DISPOSAL
TROUBLESHOOTING
No display LED on
the front panel;
No power supply
Power cord plug in correctly
Power cord
not plugged in correctly
No pictures on the screen
Set Receiver to “ON”;
Check connection and correct;
Check channel and video output and
correct (TV instruction manual)
Receiver in Standby mode;
Scart not connected tightly to video
output of television; incorrect channel
or video output selected on television.
No sound
Check connection and correct;
Increase loudness on television set;
Press the MUTE key
Audio cord connected incorrectly;
Loudness level = 0;
Muting active
Remote Control does not
operate directly
Point remote control toward the Receiver.
Replace batteries or insert correctly
Incorrect operation;
Batteries dead or inserted incorrectly
Poor picture quality signal
strength in
Check all wire connections. Check the
“Automatic channel search” menu, correct
alignment of your antenna
Signal strength to lowa
On-Screen Error Message
“Searching for signal”
Check connection and correct;
Change LNB;
Check position and correct,
Check the signal strength in the “Automatic
channel search” menu
Antenna cable not connected
or not tight;
LNB defective;
Incorrect position of the
satellite antenna;
LNB is set to “OFF” in LNB
Setting menu
On-Screen Error Message
“No Channel”
Scan of in “Automatic channel search ” or
“Manual channel search” menu
Satellite not yet set
On-Screen Error Message:
“Please check the smart card”;
“Please insert the Smart card”
(depend on model)
Check the Smart card.
“insert the Smart card”
Smart card:
-not plugged in correctly;
-not plugged in.
MF68-00367A-00_Eng 10/7/05 1:33 PM Page 32
