Samsung DCB-9401R, Инструкция по эксплуатации

Страница: 33 / 33

GB-27
DCB-9401R
GB
GB-26
D I G I T A L C A B L E R E C E I V E R
DCB-9401R
TECHNICAL SPECIFICATIONS
Power supply
Type : SMPS
Input voltage : AC 100-240V~, 50/60 Hz
Fuse rating : 250 V/T1.6AH
Tuner & Demodulator
Input Frequency : VHF,UHF BAND(50~870 MHz)
DEMODULATION : QAM DVB-C
SYMBOL RATE : MAX 7 Msps
Constellation : 16, 32, 64, 128, 256 QAM
CABLE OUT : LOOPOUT FOR ANALOG RECEIVER
Video decoder
System decoding : MPEG 2 ISO/TEC 13818
(Transport Stream)
Profile and level : MPEG 2 MP@ML (4:2:2)
Data rate : 1 ~ 15 Mb/s
Video formats : 4:3 (normal) & 16:9 (widescreen)
Picture resolution : 720(H) x 576(V) x 50 fields/sec
Audio Decoder
System decoding : MPEG 1 ISO/TEC 11172~3 layer I & II
Audio mode : MONO, DUAL, STEREO, JOINT STEREO
Sampling frequency : 32, 44.1, 48 kHz
BASE-BAND AUDIO/VIDEO OUTPUT
VIDEO PAL
Interface :
2 SCART (AV1, AV2)
Impedance : 75 Ω
Output level : 1Vp-p
AUDIO Interface : SCART
Impedance : 600 balance
Output level : 2.0Vp-p max (controllable)
S/PDIF (Digital Audio Output)
MEMORY
Flash 2MB
SDRAM 8MB
PHISICAL SPECIFICATION
Size (W x D x H) 233 x 176 x 38 mm
Weight (Net) 0.95Kg
Problem Possible cause Solution of the problem
No display LED on Power cord Power cord plug in correctly
the front panel; not plugged in correctly
No power supply
No pictures on the screen Receiver in Standby mode; Set receiver to “On”;
SCART not connected tightly Check connection and correct;
to video output of television;
incorrect channel or video
Check channel and video output and
output selected on television correct (TV instruction manual)
No sound Audio cord connected Check connection and correct;
incorrectly;
Loudness level = 0;
Increase loudness on television set;
Muting active Press the MUTE key
Remote Control does not incorrect operation; Point remote control
operate directly towards the Receiver.
Batteries dead or inserted Replace batteries or insert correctly
incorrectly
Poor picture quality Signal strength to low Check all wire connections. Check the
signal strength in the “Scanning” menu, correct
alignment of your antenna
On-Screen Error Message cable not connected or not Check connection and correct
“Searching for signal” tight
On-Screen Error Message Channel lists not installed Scan channels. Please go to Installation
“Channel data does not menu
exist.”
On-Screen Error Messages: Smartcard: (depend on model)
“Please check the - not plugged in correctly; Check the Smartcard.
Smartcard”; - not plugged in. “Insert the Smartcard.”
“Please insert the
Smartcard”.
The device, packaging material (e.g. Styrofoam) and the batteries must never be disposed of with
household refuse. Please obtain appropriate information about the regulations in your community,
and dispose of all refuse in accordance with regulations at the separate locations provided.
DISPOSAL
TROUBLESHOOTING
MF68-00340A_GB_1105 11/5/04 11:38 AM Page 26