Samsung Electronics
7-2
Troubleshooting
7-1-4. Zero point and Inclination Adjustment
1. Turn the power on again and set time initial condition to Ò8888Ó.
2. Put a dish inside the cooking space.
3. Press the sensor defrost( ) and power level/more,less( ) keys simultaneously until Ò0000Óis
displayed (about 5 seconds).At this time lamp and the rotating dish motor are on.
4. After 10 seconds, A normal neading is between 3150 and 3650.
5. Put the 1Kg standard weight at the center of the glass tray and close the door.
(When setting the 1Kg weight, put the metal rack, roasting spit, glass bowl and two skewers on the
glass tray. Then do the zero point adjustement.)
6. Press the sensor reheat( ) and power level/more,less( ) keys simultaneovsly until the Ò1111Óis
displayed. (about 5 seconds). At this time lamp and the rotating dish motor are on.
7. After 10 seconds, A normal reading is between 0350 and 0650.
8. Press the cancel key to complete the adjustment.
7-1-5. Error codes
(Metal Rack) (roasting spitspit)
(two skewers)
(glass bowl)
Error indication
Cause of occurrence
Management method
Remarks
E0
Gas sensor open/short
Check the connection and
Automatic
(sensor value
cooking reheating
reheating
between 6 and 211)
Put the power switch again and
and use it after 10 minutes.
E1
Exceeds of T1 time limit
First press the cancel key and
Automatic
(gas sensor)
check if the food is positiotes
reheating
E4
Problem with the weight
Exchange the weight sensor
sensor (Output frequency=0Hz) Check the wire connection
E5
Excess of maximum weight
Cook within 4Kg
(The total weight exceeded
4Kg)
E6
Excess of maximum allowed
When cooking 300g or less,
time with maximum load
cook within 10minutes.
(When cooking food that
weight less tman 300g the
maximum time is 10 minutes.)
E8
No tray (Occurs if oven is
Install the rotating dish
operated without the rotating
dish.)
E10
Problen with the EEPROM
Replace the PCB assy
