39
Final check and trial operation
1)
Use of “Temperature control of discharge air” or target temperature of discharge air in cooling/heating
can be set with the service mode of a wired remote controller. (Refer to the installation manual of a wired
remote controller.)
2) When using temperature control of discharge air, thermo on/off of Indoor unit is decided by set room
temperature and room temperature, and the temperature of discharge air is adjusted to meet the target
temperature of discharge air in thermostat On section.
3) When using temperature control of discharge air, the temperature of discharge air cannot always be
adjusted to the target temperature due to external conditions or protective control of the outdoor unit.
❋
Temperature control of discharge air can be set with DMS as well.
Setting temperature control of discharge air
Providing information for user
To complete the installation, perform the following checks and tests to ensure that the air conditioner
operates correctly.
Check the following:
•
Strength of the installation site
• Tightness of pipe connection to detect gas leak
•
Electric wiring connection
• Heat-resistant insulation of the pipe
•
Drainage
• Grounding conductor connection
•
Correct operation (follow the steps below)
After finishing the installation of the air conditioner, you should explain the following to the user.
Refer to appropriate pages in the user & installation manual.
1) How to start and stop the air conditioner
2) How to select the modes and functions
3)
How to adjust the temperature and fan speed
4)
How to adjust the airflow direction
5) How to set the timers
6)
How to clean and replace the filters
NOTE
•
When you complete the installation successfully, hand over the user & installation manual to
the user for storage in a handy and safe place.
DVM Big Duct_EU_IM_DB68-05047A-01_EN_16.03.30.indd 39
2016/4/7 15:54:53