8
Checking the remote controller
Remote controller buttons
• Point the remote controller towards the remote controller receiver of the indoor unit.
• When you properly press the button on the remote controller, you will hear beep sound from the indoor unit and a transmit
indicator(
) appears on the remote controller display.
• When you press [2
nd
F] button, the indicator will be displayed on the remote controller and you can change
the functions on the remote controller as listed below.
d'light Cool
Temp/Humi, Auto Clean
Beep Off, good’ sleep
Display Off, On Timer
Time Set function.
If you select the function under the button while the function of the button is switched by 2
nd
F button,
the 2
nd
F function is canceled.
Remote controller display
On Timer
Set the On Timer on.
Off Timer
Set the Off Timer on.
Smart Saver
Less energy usage makes your space
cool between the temperature range of
24°C~30°C.
Auto Clean
Auto clean function – Dry inside of the
indoor unit to get rid of odor.
Fan
Adjust how much air flows through the air
conditioner with the 4 different fan speeds
such as Auto/Low/Medium/High.
Set the
mode on.
Set/Cancel
Cancel the timer/
mode.
2
nd
F
Switch the function of the button on the
remote controller.
Air swing
Activate/Deactivate air flow blade movement
automatically up and down.
Mode
Set one of the 5 operating modes
(see pages 10~11 for instructions).
Quiet
Reduce noise generated from an indoor unit
during operation.
Power
Turn on/off the air conditioner.
Temp + -
Increase/Decrease the temperature by 1˚C.
d'light Cool
Set the d'light Cool function on/off.
Turbo
Operate in auto fan speed to cool quickly.
SPi
Set the
SPi
function on/off.
Temp/Humi
• Display the room humidity level and temperature value for 5
seconds on the indoor unit display:
- Hi : High (If the relative humidity is 70% or higher)
- Sd : Standard (If the relative humidity is lower than 70%)
- For room temperature will be displayed the value.
Beep off
To silence the beep sound when pressing the button.
Time set
Set the current time
Display off
To turn off the display light
Before using the functions of the remote controller, you should set the current time. (Refer to p.14)
AQV09K&Y@@_Jungfrau_IBIM_E_32448A.indd 8
2011-3-19 15:44:46
