Samsung AM280FNHDEH, Руководство по установке, Страница: 35 / 40

35
Setting an indoor unit address and installation option (Continued)
Changing a particular option
Option SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
Explanation PAGE MODE
The option mode
you want to change
The tens’ digit of an
option SEG you will
change
The unit digit of an
option SEG you will
change
Changed value
Remote
Controller
Display
Indication
and Details
Indication Details Indication Details Indication Details Indication Details Indication Details Indication Details
0 D
Option
mode
1~6
Tens’ digit
of SEG
0~9
Unit digit of
SEG
0~9
The changed
value
0~F
You can change each digit of set option.
Option SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
Explanation PAGE MODE
The option mode
you want to change
The tens’ digit of an
option SEG you will
change
The unit digit of an
option SEG you will
change
C
hanged value
Indication 0 D 2 1 7 1
• When changing a digit of an indoor unit address setting option, set the SEG3 as ‘A’.
• When changing a digit of indoor unit installation option, set the SEG3 as ‘2’.
Ex) When setting the ‘buzzer control’ into disuse status.
Note

If you are using heat pump model, mixed operation mode (two or more indoor units operating in different operation mode
simultaneously) is not available when the indoor units are connected to same outdoor unit. If you set the master indoor unit
with a remote controller, outdoor unit will operate in the mode which was set in the master indoor unit.
Setting temperature control of discharge air
1 Use of “Temperature control of discharge air” or target temperature of discharge
air in cooling/heating can be set with the service mode of a wired remote
controller. (Refer to the installation manual of a wired remote controller.)
2
When using temperature control of discharge air, thermo on/off of Indoor unit is
decided by set room temperature and room temperature, and the temperature
of discharge air is adjusted to meet the target temperature of discharge air in
thermostat On section.
3
When using temperature control of discharge air, the temperature of discharge
air cannot always be adjusted to the target temperature due to external
conditions or protective control of the outdoor unit.
Temperature control of discharge air can be set with DMS as well. Note
NASA_Big Duct_AM@@@FNHDEH@_IM_EN_03653A-06.indd 35 2016-12-01 오후 3:07:01