34
English
Installation Procedure
Instal
lation Pr
oc
edur
e
Step 14 Setting the indoor unit
addresses and the installation options
You cannot set both of the indoor unit addresses and
the installation options in a batch: set both of them
respectively.
Common steps for setting the addresses and
options
Low Temp button
High Temp button
Mode button
Low Fan button
High Fan button
Setting the
option values
Entering the
mode for setting
the options
NOTE
• The remote control display and buttons may vary
depending on the model.
1
Enter the mode for setting the options:
a
Remove the batteries from the remote control,
and then insert them again.
b
While holding down the
(High Temp) and
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
c
Make sure that you are entered to the mode for
setting the options:
2
Set the option values.
CAUTION
• The total number of available options are 24: SEG1 to
SEG24.
•
Because SEG1, SEG7, SEG13, and SEG19 are the page
options used by the previous remote control models,
the modes to set values for these options are skipped
automatically.
• Set a 2-digit value for each option pair in the following
order: SEG2 and SEG3
→
SEG4 and SEG5
→
SEG6
and SEG8
→
SEG9 and SEG10
→
SEG11 and SEG12
→
SEG14 and SEG15
→
SEG16 and SEG17
→
SEG18 and
SEG20
→
SEG21 and SEG22
→
SEG23 and SEG24
SEG1
SEG2
SEG3
SEG4
SEG5
SEG6
0
X
X
X
X
X
SEG7
SEG8
SEG9
SEG10
SEG11
SEG12
1
X
X
X
X
X
SEG13
SEG14
SEG15
SEG16
SEG17
SEG18
2
X
X
X
X
X
SEG19
SEG20
SEG21
SEG22
SEG23
SEG24
3
X
X
X
X
X
On (SEG1 to SEG12)
Off (SEG13 to SEG24)
