Samsung AC RNJDKG Series, Руководство по установке

Страница: 16 / 28

16
Installation Procedure
Ins
tallation Pr
oc
edur
e
English
Step 12 Setting the indoor unit
addresses and the installation options
• Set the indoor unit address and installation option
with remote controller option. Set the each option
separately since you cannot set the ADDRESS setting
and indoor unit installation setting option at the same
time. You need to set twice when setting indoor unit
address and installation option.
• Please use the proper wireless remote controller
which can set 24 digit option code.
• Please refer to the wired remote controller
installation manual for setting with the wired remote
controller.
Common steps for setting the addresses and
options
Low Temp Button
High Temp Button
Mode change
Low Fan Button
High Fan Button
Option setting
mode
Entering mode
for setting
option
NOTE
• The remote control display and buttons may vary
depending on the model.
1 Enter the mode for setting the options:
a Remove the batteries from the remote control,
and then insert them again.
b While holding down the (High Temp) and
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
c Make sure that you are entered to the mode for
setting the options:
2 Set the option values.
CAUTION
• The total number of available options are 24: SEG1 to
SEG24.
• Because SEG1, SEG7, SEG13, and SEG19 are the page
options used by the previous remote control models,
the modes to set values for these options are skipped
automatically.
• Set a 2-digit value for each option pair in the
following order: SEG2 and SEG3
→ SEG4 and SEG5
→
SEG6 and SEG8
→
SEG9 and SEG10
→
SEG11 and
SEG12 → SEG14 and SEG15 → SEG16 and SEG17 →
SEG18 and SEG20
→
SEG21 and SEG22
→
SEG23 and
SEG24
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0 X X X X X
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1 X X X X X
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2 X X X X X
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3 X X X X X
On (SEG1 to SEG12) Off (SEG13 to SEG24)