Samsung 670, Руководство по установке

Страница: 41 / 74

41
English
y
The RJP can be restored to its factory default settings by pressing the A/V and HDMI buttons simultaneously and
holding them for 10 seconds. When all LEDs blink 5 times, the factory restore is complete.
y
The RJP will automatically turn off any LEDs after 5 minutes to avoid unnecessary light pollution in the hotel room.
The LEDs that were turned off will turn on again if the guest touches any of the buttons, and the 5-minute timer
will restart. If the guest then touches another source button, the TV will change to the selected source and the
corresponding LED will be illuminated.
y
After an RJP Reset or a TV Power OFF/ON, it takes approx. 10 seconds to establish communication between the TV and
the RJP.
y
The following table shows the approximate time in seconds to switch from the TV to the input source, based on the
priority.
✎
Scenario 1: When no inputs are connected.
Source To Connect
AV 2 Sec
PC 0.7 Sec
HDMI 3.9 Sec
✎
Scenario 2: When two or more inputs are connected and an Input source is disconnected and then reconnected.
Source Disconnect To Connect Total
AV 4.5 Sec 2 Sec 6.5 Sec
PC 0.7 Sec 0.7 Sec 1.4 Sec
HDMI 3.9 Sec 3.9 Sec 7.8 Sec
✎
E.g. If the RJP has all its live sources AV, PC and HDMI connected, AV is the highest priority. If the RJP is in
HDMI mode, and a guest removes and reconnects the AV, the minimum time required to switch to the AV is 6.5
seconds.
y
To connect audio (iPod or another MP3 player), Music mode should be ON and Jack Ident detect should be OFF.
y
A/V, PC and HDMI input sources are supported.