Samsung 592-2933 series, Руководство пользователя

Страница: 24 / 56

24
TROUBLESHOOTING
Check these solutions if your washer…
Will not start . .

Make sure the lid is firmly closed, check the fuse or reset the
circuit breaker.

Make sure your Washer is plugged in.

Make sure the water faucets are on.

Make sure to press the Power button, then hit the Start/
Pause button, to start your washer.

Before your Washer starts to fill, it will make a series of
clicking noises to check the door lock and do a quick drain.
(then it is starting if it is doing this)
Has no water or not enough water . .

Turn both faucets on fully.

Straighten the water inlet hoses.

Disconnect hoses and clean screens. Hose filter screens may
be clogged.
There is detergent remains in the automatic dispenser
after the wash cycle is complete .

Make sure your Washer is running with sufficient water
pressure.Are the faucets open all the way.
Vibrates or is too noisy .

Make sure your Washer is set on a level surface. If the
surface is not level, adjust your Washer feet to level the
appliance.

Make sure your Washer is not touching any other object.

Make sure the laundry load is balanced.
Stops .

Plug the power cord into a live electrical outlet.

Check the fuse or reset the circuit breaker.

Close the lid and press the Start/Pause Button to start your
Washer.
For your safety, your Washer will not spin unless the lid is
closed.

There may be a pause or soak period in the cycle. Wait
briefly and it may start.

Check the screens on the inlet hoses at the faucets for
obstructions.
Clean the screens periodically.
Fills with the wrong temperature water .

Turn both faucets on fully.

Make sure the temperature selection is correct.

Make sure the hoses are connected to the correct faucets.
Flush water lines.

Disconnect the hoses and clean the screens. The hose filter
screens may be clogged.

While your Washer is filling, you may notice just hot and/
or just cold water going through the dispenser when cold
or warm wash temperatures are selected. This is a normal
function of the automatic temperature control feature as your
Washer determines the temperature of the water.
Lid
locked or will not open .

Press the Start/Pause Button to stop your Washer.

It may take a few moments for the lid lock mechanism to
disengage.
Does not drain and/or spin .

Check the fuse or reset the circuit breaker.

Straighten the drain hoses. Eliminate kinked hoses. If there is
a drain restriction, call for service.

Close the lid and press the Start/Pause Button. For your
safety, your Washer will not spin unless the lid is closed.
Load is too wet at the end of the cycle .

Use the High spin speed.

Use high efficiency detergent to reduce over–sudsing.

Load is too small. Very small loads (one or two items) may
become unbalanced and not spin out completely.

Load is too large. Oversized or bulky loads may become
unbalanced and not spin out completely.

Check for kink drain hose.
Leaks water .

Make sure all hose connections are tight.

Make sure the end of the drain hose is correctly inserted and
secured to the drainage system.

Avoid overloading.

Use high efficiency detergent to prevent over–sudsing.
Has excessive suds .

Use high efficiency detergent to prevent over-sudsing.

Reduce the detergent amount for soft water, small or lightly
soiled loads.

Non-HE detergent is NOT recommended.
F900A WASHER_KENMORE_USER MANUAL_592-29336_DC68-03133N-01_EN.indd 24 2015/12/15 16:51:43