13
FROM MIXER
LINE INPUT
LINE INPUT
~
AC INPUT
115V / 60Hz, 800W
~
AC INPUT
115V / 60Hz, 800W
PHASE
OFF
AUTO ON
POWER
PEAK
VOLUME
FROM EXTERNAL AMPLIFIER
SPEAKER OUTPUT
TO PASSIVE SATELLITE SPEAKERS
SWEEP Hz
PREAMP LEVEL
INPUT
OUTPUT
70
40
180
5
0
10
+
-
L
R
-
+
ON
0
°
180
°
+
-
L
R
-
+
R
R
L
L
SUB120 120 WATT 10" SUBWOOFER
Connecting the SUB120
Mono Sub With Active Satellites
If you have active studio monitors, installation is easy through the SUB120’s LINE LEVEL inputs and outputs.
Below is a typical system set up using the SUB120 with a mixer and a pair of active satellite speakers. The
SUB120’s input and outputs utilize industry standard RCA connectors. For a detailed wiring diagram, see the
section SUB120 Connections on page 15. Follow the steps below the diagram to set up your system.
•
Lower your mixer’s master outputs to all the way off.
•
Connect the mixer’s left output to the SUB120’s LEFT LINE INPUT and the mixer’s right output to the
SUB120’s RIGHT LINE INPUT. Now connect the SUB120’s LEFT LINE OUTPUT to the input of the left
powered satellite, and the SUB120’s RIGHT LINE OUTPUT to the input of the right powered satellite.
•
Now adjust the SWEEP control to the desired frequency. Consult your studio monitors owner’s manual
for a recommended crossover point. You can also use your ears by adjusting the SWEEP control to the
frequency that sounds good to you. A good place to start is about 70 Hz.
•
Now set the level of your power amp up to the normal operating level. Run an audio signal (like some
music from a CD) through your mixer and raise the level to a comfortable listening level. Now slowly
raise the SUB120 VOLUME control and listen to the low frequency output. Adjust the SUB120 to the level
of low frequency output that you like. Now, when you raise and lower your mixer’s output, the SUB120
and satellites will track at the same relative volume.
