Samson series 43, Перевод оригинальной инструкции

Страница: 19 / 56

EB 2430 EN 4-1
Shipment and on-site transport
4 Shipment and on-site trans-
port
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Check that
the specifications on the nameplate
match the specifications in the delivery
note. See the 'Markings on the device'
section for nameplate details.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).
3. Determine the weight and dimensions of
the units to be lifted and transported in
order to select the appropriate lifting
equipment and lifting accessories. Refer
to the transport documents and the 'De-
sign and principle of operation' section.
4.2 Removing the packaging
from the control thermostat
The control thermostat is delivered as single
component.
Î
Do not open or remove the packaging
until immediately before lifting to install
the control thermostat into the pipeline.
Î
Leave the control thermostat in its trans-
port container or on the pallet to trans-
port it on site.
Î
Dispose and recycle the packaging in
accordance with the local regulations.
4.3 Transporting and lifting the
control thermostat
Due to the low service weight, lifting equip-
ment is not required to lift and transport the
control thermostat (e.g. to install it into the
pipeline).
Î
Leave the control thermostat in its trans-
port container or on the pallet to trans-
port it.
Î
Observe the transport instructions.
Transport instructions
Î
Protect the control thermostat against
external influences (e.g. impact).
Î
Do not damage the corrosion protection
(paint, surface coatings). Repair any
damage immediately.
Î
Protect the control thermostat against
moisture and dirt.
Î
The permissible ambient temperature of
the control thermostat is between –20
and +80 °C/–4 to +175 °F.