Samson RSX M10a, Руководство пользователя

Страница: 11 / 20

RSX Active Loudspeakers 11
10. MIX Output - Male XLR connector used to link multiple speaker cabinets.
NOTE: When connecting a loudspeaker to the Line Output of the RSX loudspeaker, it is important to
power on the RSX loudspeaker first, then power on the linked speaker. When powering down the
system, it is recommended to turn off all linked speakers, then power off the RSX loudspeaker.
11. Power Switch - This rocker switch turns on and off the speaker’s main power. The switch lights
RED when the amp is active.
NOTE: It is important to remember the Golden Rule of audio… “LAST ON, FIRST OFF.” Translated, this
means that when turning on your system, you should always turn your powered speakers on LAST, and
when turning your system off, turn your powered speakers off FIRST. This helps avoid any loud pops
caused by inrush current at power up, or down, which can sometimes damage loudspeakers.
12. AC Power Inlet - Connect the supplied standard 3-prong IEC power cable here.
Note: Never disconnect the plug’s ground pin. It is dangerous and can result in electric shock!
13. Fuse Cover - The fuse is located behind the fuse cover. Always replace fuses with the same type of
fuse.
14. Voltage Selection Switch - This switch is used to select the amplifiers operating voltage.
NOTE: Before using your speaker, be sure the voltage selection switch is set to the correct voltage
for your country. Be sure to install the properly rated fuse when changing the operating voltage.
RSX112a & RSX115a Rear Panel Layout