Samson 3241-1-Gas, Монтаж и эксплуатация

Страница: 28 / 56

28 EB 8020-1 EN
Measures for preparation
Risk of valve damage due to incorrectly at ‑
tached slings.
The welded‑on lifting eyelet on SAMSON
actuators is only intended for mounting and
removing the actuator as well as lifting the
actuator without valve. Do not use this lifting
eyelet to lift the entire control valve assembly.
− When lifting the control valve, make sure
that the slings attached to the valve body
bear the entire load.
− Do not attach load‑bearing slings to the
actuator or any other parts.
− Observe lifting instructions (see sec ‑
tion 4.2.2).
Our after‑sales service can provide more de‑
tailed transport and lifting instructions on re ‑
quest.
4.2.1 Transporting
The control valve can be transported using
lifting equipment (e.g. crane or forklift).
Î
Leave the control valve in its transport
container or on the pallet to transport it.
Î
Observe the transport instructions.
Transport instructions
− Protect the control valve against external
influences (e.g. impact).
− Do not damage the corrosion protection
(paint, surface coatings). Repair any
damage immediately.
− Protect the control valve against moisture
and dirt.
− The permissible transportation tempera‑
ture of standard control valves is –20 to
+65 °C.
Contact our after‑sales service for the trans‑
portation temperatures of other valve ver ‑
sions.
4.2.2 Lifting
To install a large valve into the pipeline, use
lifting equipment (e.g. crane or forklift) to lift
it.
Lifting instructions
− Secure slings against slipping.
− Make sure the slings can be removed
from the valve once it has been installed
into the pipeline.
NOTICE !
Tip
Note