www.larius.com
9
VIKING
ED. 03 - 09/2020 - Cod. 150163
Never point the spray gun at yourselves or at
other people. The contact with the casting can
use serious injuries. In case of injuries caused by
the gun casting, seek immediate medical advice
specifying the type of the product injected.
The drain valve is a safety valve too. When working
at the maximum pressure available, releasing
the gun trigger sudden increases of pressure
can occur. In this case, the drain valve opens
automatically eliminating part of the product from
the recirculating tube. Then it closes so as to go
back to the first working conditions.
SPRAY ADJUSTMENT
• Slowly turn clockwise the pressure control knob to reach
the pressure value in order to ensure a good atomization of
the product.
• An irregular and marked spray on the sides indicates a low
working pressure. On the contrary, a too high pressure
causes a high fog
(“overspray”)
and waste of product.
• In order to avoid overthickness of paint, let the gun advance
sideways
(right-left)
when spraying.
• Always paint with regular parallel bands coats.
• Keep a safety and constant distance between the gun
and the support to be painted and also keep yourselves
perpendicular to it.
CLEANING AT THE END OF THE
WORK
• Reduce pressure to the minimum
(turn counterclockwise the
pressure control knob
(J1)
).
• Press the
ON/OFF
switch
(J2)
placed on the box of the
electric motor, to stop the equipment.
OFF
0
• First release the residual pressure from the gun by holding
it pointed down towards the paint container, then open the
re-circulation valve.
• Lift the suction pipe and replace the product tank with that
of the solvent
(ensure it is compatible with the product being
used).
• Unscrew the gun nozzle
(do not forget to clean it with solvent!).
• Turn the
ON-OFF
switch
(J2)
on the
"ON" (I)
position and
rotate the pressure setting knob
(J1)
slightly clockwise.
• Make sure the solvent recycles the washing fluid from the
return tube.
• Close the re-circulation valve
(J3)
.
• Point the gun at the product tank and, keeping the trigger
pressed, release the remaining product till a clean solvent
comes out. Now, release the trigger.
• Lift again the suction pipe and remove the solvent tank.
• Now point the gun at the solvent tank and press the trigger
so as to recover the residual solvent.
J1
J1
J2
J3
J
Fig. 1J
Fig. 2J
Fig. 3J
Содержание LARIUS VIKING
Страница 26: ...I n t e n t i o n a l l y b l a n k p a g e...
