www.larius.com
10
GIOTTO
ED. 11 - 09/2020 - Cod. 150159
Apparecchi per verniciatura
ATTENZIONE
UTILIZZARE GRUPPI ELETTROGENI
CON ALTERNATORE ASINCRONO
http: www.larius.com
Paint spraying units
USE POWER UNITS WITH
ASYNCHRONOUS ALTERNATOR
e-mail [email protected]
L
WARNING PLATE
®
®
REPLACING HYDRAULIC OIL
After operating for 100 hours, replace the oil in the pump;
• Discharge the waste oil through the
hydraulic filter
fitted
at the bottom of the pump casing.
• Clean and, if necessary, replace the worn seals.
• Replace the filter in its seat by screwing it tightly.
• Fill the pump with the recommended oil until it reaches
the maximum level.
• Then, substitute the oil every 250 hours.
CLEANING THE MOTOR COOLING FAN GUARD
Clean the motor cooling fan protection guard periodically to
ensure the best cooling.
I
ROUTINE MAINTENANCE
TOP UP HYDRAULIC OIL
With each start up, check the hydraulic oil level by looking
through the gauge on the side of the hydraulic body. If
necessary, use, to top up the level:
RELEASE THE SUCTION VALVE
If the pump malfunctions, release the suction valve fitted on
the head of the pump in the following way:
• Remove the suction hose fitting and release the valve
by inserting a rigid rod (I1) with a diameter of no more
than 15 mm.
CLEANING THE COMPRESSION VALVE
When the compression valve must be removed, clean it with
specific solvents depending on the type of paint used and
refit all parts by inverting the removal order.
I1
AGIP DICREA 150 type hidraulic oil
AGIP DICREA 150 type hidraulic oil
