www.larius.com
8
GIOTTO
ED. 11 - 09/2020 - Cod. 150159
G
G1
G2
G3
G4
NEVER point the spray gun at yourselves or at
other people. The contact with the casting can
use serious injuries. In case of injuries caused
by the gun casting, seek immediate medical advice specifying
the type of the product injected.
The drain valve is a safety valve too. When
working at the maximum pressure available,
releasing the gun trigger sudden increases of
pressure can occur. In this case, the drain valve
opens automatically eliminating part of the product from the
recirculating tube. Then it closes so as to go back to the first
working conditions.
WORKING
START OF THE PAINTING OPERATIONS
• Use the tooling after performing all the SETTING UP
operations above described.
• Dip the suction pipe (G1) into the product tank.
• Open the re-circulation valve (G2).
• Press the ON/OFF switch of the equipment and turn a
little the pressure control knob (G3) clockwise, so as the
machine works at the idle speed.
SPRAY ADJUSTMENT
• Slowly turn clockwise the pressure control knob to reach
the pressure value in order to ensure a good atomization
of the product.
• An irregular and marked spray on the sides indicates
a low working pressure. On the contrary, a too high
pressure causes a high fog
(“overspray”)
and waste of
product.
• In order to avoid overthickness of paint, let the gun
advance sideways
(right-left)
when spraying.
• Always paint with regular parallel bands coats.
• Keep a safety and constant distance between the gun
and the support to be painted and also keep yourselves
perpendicular to it.
• Make sure the product recycles from the return tube
(G4).
• Close the re-circulation valve.
• At this point the machine will continue to suck the
paint product until the delivery hose is completely full.
Afterwards, the product will re-circulate automatically.
