Sames inocoat Inogun A, Инструкция по эксплуатации, Страница: 32 / 87

32
Member of Exel group
DRT7133
D - 2023/01
6. Maintenance
Preventive maintenance is an essential part of production and ensures the reliability of the installation. As a reminder,
the performance of equipment can only be guaranteed if a minimum of control and cleaning operations are performed
on this equipment.
Soiling and wear of the Inogun A projectors caused by the passage of powder depend on the
operating and application conditions and the production rates
Switch off the power supply to the control module before connecting the spray gun. Before
disconnecting the spray gun, switch off, disconnect the power supply to the Inocontroller or
Inobox (otherwise, a malfunction may occur).
6.1. Summary table of maintenance operations
The maintenance intervals indicated in the procedures below are only indicative. The user will have to create his own
maintenance schedule as he use Sames equipment.
Procedure Detail Duration Frequency
Cleaning
A
A1 Cleaning of projector exterior 2 min 8 hours
A2 Cleaning of electrode support and deflector 2 min 8 hours
Replacement
B
Holding flange maintenance
B1 Replacement of air nipple 2 min -
B2 Replacement of o-ring 2 min -
C
Rear body maintenance
C1 Replacement 5 min -
D
Gun assembly maintenance
D1 Powder tube and penetrant testing version powder tube 2 min -
D2 Protective cover assembly 2 min -
D3 Replacement of HVU 5 min -
E
Maintenance of 60° and 90° nozzle adapters
E1 Replacement of o-rings and 60° and 90° elbows 5 min -