Index revision : A
11
7140
2. Introduction
2.1. General - Inorecip V
The
Inorecip V
reciprocator is designed to equip automatic powder coating installations.
It is composed of a mechanism controlled by an
Inomotion
control module placed in an elec-
trical cabinet.
It allows to drive, with a vertical reciprocating movement, powder projectors, for example:
• 12
Inogun A
powder projectors,
• 4
Inobell
powder projectors.
In case of use with a booth, to avoid crushing of limbs (fingers, hands...) between the projectors
and the booth, it is imperative to install and adjust the limit stops at the upper and lower parts
of the stroke as well as protective barriers around the equipment.
2.2. General - Inomotion
The Inomotion control module allows to remotely control the vertical reciprocating mechanism
of the
Inorecip V
and the horizontal positioning of the
Inorecip H
(option).
It is connected by power and control cables to the box located at the rear of the
Inorecip V
.
2.3. Inorecip H (option)
The In and Out carriage
Inorecip H
is an unit placed under the
Inorecip V
reciprocator giving
it the possibility to move along a second horizontal axis.
The
Inorecip H
allows to keep a constant coating distance whatever the width of the parts. It is
controlled via the
Inomotion
control module, which receives information from the part width
detection system.
This second axis is also often used for the automatic cleaning mode of the projectors.
DES07448
Inomotion
Power and
control cables
Inorecip H
Inorecip V
Electric box
