-
- 5 -
Figure 1-2.3 the Rear Panel
3 Initial Configuration
The initial use of SCS8000E, we recommend you to log on the MCU
Console (MCC) to configure the SCS8000E general information.
Through the direct connection of MCC and SCS8000E, you can
achieve the configuration.
Figure 1-3 SCS8000E Connection
Operations as following
1
）
Amend the IP address of the PC having installed MCC software, make sure that two IP
addresses can communicate. About the installation of MCC, please refer to Section Two.
2
）
Use network cable to connect the SCS 8000E and the PC directly, you can refer to
upper figure.
After a successful connection, log on SCS8000E through MCC software, the system will
enter the “Setup Wizard” interface, which guides you to complete various settings.
