User's manual
CIRCULAR SAW - PT
- 9 -
Inspection and repair
All inspection and repair related works should be performed with the tractor's engine off and
the tractor-cutting set combination is standstill position.
Bolts and other fasteners should be inspected on regular basis (tightening torque as per
Tab.
4). Operating with damaged or worn fasteners is not admissible.
Damaged or worn (aged 5 years or more) hydraulic hoses and other hydraulic parts should be
replaced with new ones as recommended by the manufacturer.
Examine condition of circular blades before commencing any operation. If blunt sharpen
these. Damaged or worn blades must be replaced with new ones.
Use only genuine spare parts, which can be ordered at our store or at your dealer.
When servicing hydraulic assembly, always wear protective gloves and eyewear. Hydraulic
oil leaking under pressure (16 MPa) may permeate through the skin and cause its infection
thereafter. If such is experienced, visit a doctor immediately.
In case of a fatal failure, stop the machine's drive, turn the tractor's engine off and take out the
ignition key. Then call for technical service, and if an accident (in this case: road accident)
occurs, respect first aid rules and contact responsible services.
4.2.
Relocating onto another vehicle for transport
Both the carrier and the driver shall be responsible for the machine's transport safety. Any
equipment and parts must be secured properly for transport.
The saw should be seized by any lifting device only in places indicated on the machine by the
hook sign,
To lift the machine, use only lifting devices with hoisting capacity bigger than the circular
saw’s weight provided on the data plate.
When relocating the circular saw onto another vehicle, there should be no unauthorized
personnel permitted to remain within the danger area.
Circular saw should be protected from shifting on a vehicle's trailer.
NOTE!
Securing both the danger area and activity performed shall lie under the
responsibility of the person in charge of the circular saw transporting.
4.3.
Residual risk
Despite the fact, that SaMASZ Sp. z o. o. Białystok company – the manufacturer of the
mower takes the responsibility for the machine design and manufacturing, in order to eliminate
hazard, certain risk when operating the circular saw is unavoidable. Residual risk results from
incorrect or improper behavior of the circular saw operator.
Major source of risk follows performance of these operations:
1.
Operation of the machine by minors as well as not being learned with content of the operator's
manual,
2.
Operating the saw by persons under influence of alcohol or other abusive substances,
3.
Not exercising safety when transporting and operating,
4.
Transport of persons remaining on the machine,
5.
Presence of persons and animals within the circular saw's operation range,
6.
Performing operations related to servicing and adjustment with engine on.