Operator’s manual
Rear disc mowers
KDT
- 31 -
6.7.
Replacing the conditioner’s tines
(Models:
KDT 220 S and KDT 260 S(SL)
)
Prior to commencing any operation, check condition of bolts on which flails are set, as well as
condition of fails themselves. If flails or bolts are worn or damaed, it is necessary to replace them.
Bear in mind, that flails should be replaced in pairs (opposite) featuring the same weight
in order to keep shaft well balanced.
Not keeping the shaft well balanced may lead to premature
wearing of bearings as well as the shaft itself.
Replacement of flails
3
consists in unscrewing of nuts
2
, removing bolts
4
and mounting
brand new flails
3
(
Fig. 28
).
NOTICE:
In order to tighten screw connection use special purpose bolt M16
×60
z.
Property Class 10.9 and self-protected nut M16 z. Property Class 8.8;
torque
down until tight.
1. Scarfier shaft
2. Self-locking nut M16 z. Property Class 8.8
3. Flail
4. Bolt M16x60 kl. 10.9
Fig. 28a.
Parts of tine conditioner
1. Scarfier shaft
2. Self-locking nut M16 z. Property Class 8.8
3. Washer
4. Plastic flail
5. Bolt M16x60 kl. 10.9
6. Plastic flail insert
Fig. 28b.
Replacement of flails in light-weight conditioner roller
1
2
3
4
5
6