5
Operating Instructions
TO START:
Close DRAIN VALVE.
Position RESERVOIR
SCREENS in bottom of tank.
Position SALVAGE BASIN over
reservoir screens.
Lower SAFETY COVER over
disposer.
Press START button on
CONTROL PANEL.
(See HydroLogic Control
Operating Instructions below.)
Adjust WATER PLUME VALVE.
Recommended plume height
4” - 6”.
TO STOP:
Press STOP button on
the CONTROL PANEL.
Open DRAIN VALVE.
Remove and drain
SALVAGE BASIN.
Remove RESERVOIR
SCREENS from tank.
Do not dump waste
in tank.
Rinse SALVAGE BASIN,
SCREENS, tank interior
and separator discs
thoroughly.
6
WATER
PLUME VALVE
B
DRAIN
VALVE
D
RESERVOIR
SCREENS
SAFETY COVER
C
SALVAGE BASIN
A
CONTROL
PANEL
3
2
5
1
4
1.
Press the START button to begin
operation.
Note: If the Line Disconnect
is in the OFF position it will need to
be turned to the ON position.
•
Display will read “TANK FILL DELAY”.*
•
The pump then starts.
2.
Choose from 2 modes of operation.
On/Off Mode - Display reads “SYSTEM ON”.
Unit will run until turned off.
Water Saver Mode - Press ON/OFF to activate. The blue light will illuminate and the display will read
“SYSTEM ON”. Unit will run at a normal flow rate until the operator leaves. If the operator leaves, the display
will read “RUN TIME” and a timer will start. The unit will run at a reduced flow rate until the operator returns or
the run timer reaches 0:00. The unit will turn off when the run timer reaches 0:00. To increase or decrease the
run time, use the
+
and
-
buttons to adjust to the desired run time. If the operator returns before the run timer
reaches 0:00, the unit returns to normal operation and the run timer will reset.
Note:
An
*
appears in the upper left corner of the display when the operator is in range of the sensor.
Press the STOP button to end all operations.
HYDROLOGIC
®
CONTROL
OPERATING INSTRUCTIONS
U.S. Pat. No. 7,815,134
Line
Disconnect
Light
