Step 11
Insert the bottom end bell into the bottom of the disposer housing and pull the thermal overload though the hole
provided in the bottom end bell. Place o-ring (123- 3/4 to 3 h.p. or 222- 5-10 h.p.) around the thermal overload and push
back into bottom end bell hole. Install thermal overload cover and gasket securing them with two 10-32 hex head bolts
and washers. Place the bottom end bell on the disposer housing lining up the junction box opening in the bottom end bell
with the junction box in the disposer housing. Carefully pull all the stator wires into the junction box and make sure you
have not pinched any wires. Tap the bottom end bell into place with a rubber mallet.
Step 12
Place bottom end bell rubber insulator
(996023) in to the bottom bearing pocket of the bottom
end bell.
Step 13
Place bottom bearing (6205) over the
motor rotor shaft into the bottom bearing pocket
making sure not to crimp the bottom end bell
rubber insulator.
Note:
Bearing must seat completely in
bottom end bell.
Step 14
Place the drive washer (997002) over
threads on the motor rotor shaft and against the
bottom bearing.
Step 15
Place the friction washer (996024) over
the threaded end of the motor shaft and on top of the
drive washer.
Step 16
Place the wavy washer (987003) over the
shaft and locate it on the drive washer around the
outside of the friction washer.
Step 17
Place the retaining washer (987001) over the shaft and up against the wavy washer and the friction washer.
Step 18
Screw the 1/2” castle nut (997050) on the motor rotor shaft. This should be tightened down and then backed
off and then tighten to 48 inch lbs with a torque wrench. NOTE: Over or under torquing can damage the bearing!
Step 19
Push cotter pin (997051) through hole in motor shaft. Bend around castle nut to secure.
Note:
There should be no vertical play in the motor rotor shaft at this time.
Step 20
Turn the disposer upright and check for up and down play and that unit spins freely. Insert the shredder by
lining up the four tabs with four of the motor housing bolts and tap into place.
Step 21
Place the center gasket (996045) and remove center of gasket so that the inside diameter matches
shredder. Place top housing on motor housing and secure with the eight motor housing bolts.
Seal Kit Installation
CARDBOARD
MANDREL
(Remove in step #8)
TOP END BELL
ASSEMBLY
(Seal included)
SCREWS
TOP BEARING
CUP/CONE
4530 East 75th Terrace Kansas City, MO 64132-2081, USA
Toll Free: 1.888.725.8256
I
Fax: 1.800.832.9373
I
www.salvajor.com
Printed in USA
Form No.SKR (04-18)
