put the Z-
Wave TM Interface Controller into “association”, a
nd following its
instruction to associate the ZP3102 with other device. Close the cover back after
“association” done, afterward the ZP3102 will get into “Sleep” mode for power
saving. Support one association group (5 nodes).
Note: “Awake” mode: it is to leave the “Sleep” mode by removing the cover of
ZP3102, to allow the Z-
Wave TM Interface Controller to do “Association”.
Installation
1.
Release cover tab to open the cover.
2.
Insert a CR123A battery into the battery compartment, and LED will start to flash
slowly, which means the sensor has not yet been “inclusion”.
3.
Close the cover back to sensor.
4.
Using adhesive tape to mount ZP3102 at 2 meters above surface. To enhance
proper operation, place ZP3102 on the angle which can detect the room widely.
The solid
area means the detector’s coverage range.
Содержание S F 9250
Страница 1: ...Motion Sensor S F 9250 User Manual...
