ON
AUTO
OFF
MANUAL
ON
AUTO
OFF
MANUAL
TEST / PAIRING
TEST / PAIRING
Sleep Mode
Pairing the RT310TX with the Receiver
Change the Setpoint temperature
Frost Protection
Reset of the RT310 thermostat
Reset of the RT310TX thermostat
Installer Mode
TEST / PAIRING
RESET
TEST / PAIRING
TEST / PAIRING
TEST / PAIRING
Note:
If you are using the RT310RF pack, the pairing between the thermostat and the receiver
is already done.
Press the RESET button once. You can use a paper clip.
Your thermostat will be reset and will start up automatically.
Remove the batteries without pressing any button.
Wait 2 minutes and insert the batteries again.
Your device will be restarted.
Pairing process can take up to 9 minutes.
Press and hold TEST / PAIRING
button for 3 seconds.
Press TEST / PAIRING button
to check the connection with
the receiver.
Press TEST / PAIRING button again
to return to the main screen.
Once devices are successfully paired,
LED on the receiver will go solid red.
Press and hold TEST / PAIRING button
for 3 seconds to end the pairing
process.
Press three buttons at the same time
for 3 seconds.
Actual room temperature.
2 seconds timeout.
Press button to turn
On/Off frost protection.
Press any button to stop the Sleep Mode.
Actual room temperature.
3 sec
3 sec
3 sec
3 sec
3 sec
3 sec
3 sec
1 sec
1 sec
If you bought the RT310TX and RXRT510 separately or if you want to re-pair thermostat with the
receiver, make sure that the device is disconnected from the power supply and the switches on the
receiver have been set to AUTO and ON. Then connect the receiver to the power supply and wait for
the red LED to light steadily. Then switch to the OFF position and again to ON position quickly. The
red flashing LED will confirm entering the pairing mode.
The Frostpoint temperature can be reviewed by pressing the UP button once, but can only be
changed in Installer Mode.
When Sleep Mode is active all the thermostat functions will be paused.
When you want to change the batteries your device will use the
internal memory to backup your settings. You have 30 seconds
to change the batteries before losing your settings.
Begin the pairing process
End the pairing process
Test the pairing process
3
dxx
Function
Parameter
Default
value
d01
Temperature display increments
0.1°C or 0.5°C
0.5°C
d02
Temperature offset
+/- 3.0°C
0.0°C
d03
Frost Protection setpoint temperature
5.0°C - 17.0°C
5.0°C
TEST / PAIRING
+
−
+
−
Press or to set the temperature.
Issue Date: June 2019
V020
SALUS Controls plc
SALUS House
Dodworth Business Park South,
Whinby Road, Dodworth,
Barnsley S75 3SP, UK.
T: +44 (0) 1226 323961
E: [email protected]
SALUS Controls is a member of the
Computime Group.
Maintaining a policy of continuous product
development SALUS Controls plc reserve
the right to change specification, design and
materials of products listed in this brochure
without prior notice.
www.salus-tech.com
For PDF Installation guide please go to
www.salus-manuals.com
NOTE:
If you do not notice the “low battery” symbol displayed on the screen in time, it will shut down. In
this case, after removing the old batteries, it is necessary to wait 5 minutes before inserting the new
batteries. Otherwise, it is possible that a condenser will remain partially discharged and
i
t can prevent
the thermostat from restarting.
Содержание RT310
Страница 1: ...RT310 RT310TX RT310RF Quick Guide ...
