Tel: 886.909 602 109 Email: [email protected]
13
S3871 series solid-state power amplifiers are equipped indication for mismatch, over-temperature and
air-cooling alarms, realizing warning for mismatch of the output port, excessive temperature inside the
amplifier and abnormal operation of the air cooling fans.
7. Operation switch
The operation switches are used to control the standby and working states of the solid-state power
amplifier. After turning on the power switch on the rear panel, the working switch of the front panel is in
the standby state by default and will be switched to the working state after pressing the key.
3.2 Rear Panel Features
The configuration of the rear panel of S3871 series solid-state power amplifiers is shown in Figure 3-2.
Figure 3-2 Rear panel of S3871 series solid-state power amplifiers
1. Power switch
When the power switch, located on the rear panel, is turned on, the instrument is powered on and in the
standby status.
2. AC power input
This connector is used to input AC voltage of 220V±10% and 50Hz.
3. Ethernet port
At present, S3871 series solid-state power amplifiers support remote power control through the Ethernet
port at the upper right corner of the rear panel.
