Saluki S3331B, Руководство пользователя

Страница: 20 / 60

20
Tel: 886.2.2175 2930 Email: sales@salukitec.com
www.salukitec.com

[Normal]
Menu description: Create a new normal maker, or change the active marker from a delta marker to a normal marker. Normal marker will
information is displayed on screen (X axis value, Y axis value)

[Delta]
Menu description: Create new reference marker/delta marker, or add a reference marker to the active normal marker. The reference
marker will be set at the same X-axis value of the delta maker. If user want to move the reference marker, first move the delta marker to
the wanted place then press [Delta] again, then the reference marker will move to the same position. Delta marker information will be
display on screen ( X axis, Y axis value difference between reference marker and delta marker).

[Off]
Menu description: Turn off the selected marker.

[All Off]
Menu description: Turn off all markers.

[Marker Table On Off]
Menu description: to turn on/off the marker table display. Where there are many markers, it is convenient for data measurement.

[Marker Function]
Menu description: The [Marker Function] key is used for turning on the control instrument marker functions. The Marker Function
performs post-processing on the marker data. Its soft menu includes [Marker Noise ON/OFF], [NdB ON/OFF], [Freq Count]

[Marker Noise On Off]
Menu description: when this menu is ON, it activates the noise maker. Read out the noise power that normalizes the noise into
1Hz bandwidth near the active marker. At that time, the detector is under Sample Detector mode.

[Freq Count ]
Menu description: to turn on or off marker Freq Count. If there is no active marker, enabling this function will activate an active
marker at the center of screen. The Marker Count readout is not affected by the Frequency Offset. To facilitate normal function of
Freq Count, the SPAN/RBW should be less than 500.

[NdB ON/OFF]
Menu description: to turn on or off the NdB measurement of bandwidth values descending from signal peak point. You can input
the NdB value to be measured from the front panel.

[Marker->]
Pop up soft menus related to Marker->Function. Such menus are related to the frequency, span and marker type

[Marker → CF]
Menu description: to set the Center Frequency equal to the Marker Frequency. It can quickly move the signal to the center position
of the screen.

[Marker → CF Step]
Menu description: to set the Frequency Step equal to the Marker Frequency. The menu changes the value of frequency step.

[Marker → Start]