Saltus GFA-COT, Инструкция по эксплуатации продукта

Страница: 6 / 20

Installation EN GFA-COT
6
© Saltus Industrial Technique AB - 9839 1815 01
Installation
Installation Instructions
Assembly Instructions
The assembly procedure varies depending on the configuration. Make sure that the square drive of the
drive unit (1) matches the input gear profile (square hole) of the GFA module (2).
Functional Test
Perform a functional test before the first tightening operation, and after any performed maintenance activi-
ties.
To perform a functional test:
1. Turn the output gear wheel by hand. It should be turned easily.
2. If it is hard to turn, open the housing and check that all components are in the correct position.
3. Grease the system.